Here described steps to run VOIP solution using NetSoM development board as SIP client. E.g. here NetSoM used as OpenWrt SIP client hardware.
SIP Server setup.
Look here if you don’t have docker installed yet. In short it removes the headache of installing software with all its dependencies.
Clone the project:
build Docker image:
and run it:
where /home/user/docker-freeswitch/freeswitch_config_example is path to freeswitch_config_example folder of the repo you clone above. This config defines three client’s IDs: 1000, 1001 and 1002 with passwords same as ID. Server address set to 192.168.0.118. You have to change it to IP address of your server in dialplan/default/20-interconnect.xml and directory/private.xml files.
After you got SIP server it is time to run SIP client. One on NetSoM development board and the second on any another PC/laptop.
Running baresip client on NetSoM.
First edit config file:
comment everything in that file and add just one line:
You should see logmessage similar to following:
Running baresip client on PC/laptop.
Just install baresip:
Edit config file (probably ~/.baresip/accounts):
Similar to previous chapter comment everything in that file and add following line:
Make a call.
Now everything should be ready to make a call: you have SIP server running and two SIP clients (1001 on NetSoM development board and 1002 on laptop). Probably you have to place them in different rooms far away from each other.
So, finally, let’s make a call from NetSoM to laptop. Just type d and then address of laptop 1002. After that laptop should inform you that “the phone is ringing“. Type a to answer a call. Enjoy it!