Описание
DISCONTINUED.
REPLACEMENTS:
- Indoor LoraWAN gateway — GW-01-Wi-Fi.
- Outdoor LoRaWAN gateway — GW-01-PoE.
- Raspberry Pi LoRaWAN shield — GW-01-RPI.
Lorawan gateway GW-01.
Fully functional open source low cost solution to build LoRaWAN network.
Hardware.
GW-01 is open source low cost LoRa gateway compatible with LoRaWAN protocol. Supports OpenWrt and Armbian distributives. Consists of two boards. Top of them is based on SX1301 — 8 channel LoRa concentrator that implements LoRa physical interface. Bottom is OrangePi Zero H2+ 256Mb development board and based board.
GW-01 comes with pre-flashed OpenWrt image. OpenWrt image requires 4.5MB so onboard 2 MB flash IC replaced with 8 MB. So you can just power up the device and get working gateway. Depending on required frequency band two types of device can be ordered: 868 MHz or 915 MHz;
Software.
lora-gateway and packet-forwarder implements functionality of LoRaWAN gateway. GW-01 comes with pre-flashed OpenWrt image but if you prefer Debian like distributives you can use Armbian that boots from microSD card..
You can build OpenWrt and Armbian both from source code in a case if you need customize your LoRaWAN gateway.
Specification:
- Temperature range from 0°C to 70°C;
- 5 VDC power supply;
- Sensitivity: -139 dBm;
- Frequency: 868 MHz or 915 MHz;
- LoRaWAN protocol;
- SX1301;
Resources.
You can find all necessary sources and guides here or get them at wiki page: